Vacuum Mobile Glass Lcd Refurbishing For Iphone Samsung Smart Phone Ipad

Vacuum Mobile Glass LCD Refurbishing For Iphone Samsung Smart Phone Ipad

Working details:

1.How it works:Keep vacuum by the vacuum pump,and then Laminated by barometric pressure
 

2.Operating temperature: Constant temperature of 45 degrees
 

3.Time to achieve Vacuum state: 15 ~ 20s
 

4.Compressor power: 0.6078Mpa to 0.7091Mpa is apposite
 

5.Lowest vacuum: -0.1Mpa
 

6.Laminating time:10~15s
 

7.Laminating pressure (Pa): Pressure for Lcd lamination need to be no more than 0.15 to 0.2,
so as not to damage the LCD

Advantages:

1.easy to operate,identification of features is clear
 

2.Adjustable laminating speed and pressure as you need
 

3.With the rear pneumatic valves,pressure can be adjusted according to need
 

4.Laminating time and the vacuum time are adjustable according to need
 

5.After completing lamination,the lower mold will automatically pop up
 

6.Vacuum pressure state keep good laminating effect

Precautions:

1. notice the working pressure,operate after the pressure of chamber completely ruled out
 

2. Keep the pressure chamber clean to prevent the entry of foreign matter,so as not to damage the screen
 

3. If the lower mold does not automatically pop up after completing work,please pull it out with hand
 

4. When the lamination is ineffective,please check whether the platen there is damage
 

5. After pressing the switch,don't released until the vacuum value achieve 0.02 on vacuum meter.
 

6. For closing pressure,the smaller the better,and the closing speed is the slower the better, as long as falling normally;
 

7. If the machine jitter when platen rises , it may be closed too fast
 

8. Pay attention to electrical safety, turn off the power completely.